Recommended Suppliersmore
2-(Dimethylamino)ethyl methacrylate 2867-47-2 MSDS

  Product identifiers
    Product name        : 2-(Dimethylamino)ethyl methacrylate    
    CAS-No.        : 2867-47-2    
  Relevant identified uses of the substance or mixture and uses advised against
    Identified uses        : Laboratory chemicals, Manufacture of substances    

  Classification of the substance or mixture
  Classification according to Regulation (EC) No 1272/2008 [EU-GHS/CLP]
    Acute toxicity, Oral (Category 4)
    Acute toxicity, Dermal (Category 4)
    Skin irritation (Category 2)
    Eye irritation (Category 2)
    Skin sensitization (Category 1)
  Classification according to EU Directives 67/548/EEC or 1999/45/EC
    Harmful in contact with skin and if swallowed. May cause sensitization by skin contact. Irritating to eyes
    and skin.
  Label elements
  Labelling according Regulation (EC) No 1272/2008 [CLP]
    Signal word        Warning    
    Hazard statement(s)
    H302 + H312        Harmful if swallowed or in contact with skin    
    H315        Causes skin irritation.    
    H317        May cause an allergic skin reaction.    
    H319        Causes serious eye irritation.    
    Precautionary statement(s)
    P280        Wear protective gloves/ protective clothing.    
    P305 + P351 + P338        IF IN EYES: Rinse cautiously with water for several minutes. Remove    
    contact lenses, if present and easy to do. Continue rinsing.
    Supplemental Hazard        none    
  According to European Directive 67/548/EEC as amended.
    Hazard symbol(s)
    R21/22        Harmful in contact with skin and if swallowed.    
    R36/38        Irritating to eyes and skin.    
    R43        May cause sensitization by skin contact.    
    S26        In case of contact with eyes, rinse immediately with plenty of water and    
    seek medical advice.
    S36/37        Wear suitable protective clothing and gloves.    
  Other hazards

    Synonyms        : Methacrylic acid 2-(dimethylamino)ethyl ester    
    Formula        : C8H15NO2    
    Molecular Weight        : 157,21 g/mol    
    Component        Concentration    
  2-Dimethylaminoethyl methacrylate
    CAS-No.        2867-47-2        -    
    EC-No.        220-688-8    
    Index-No.        607-132-00-3    
    CAS-No.        150-76-5        0,1 - 1 %    
    EC-No.        205-769-8    
    Index-No.        604-044-00-7    

  Description of first aid measures
  General advice
    Consult a physician. Show this safety data sheet to the doctor in attendance.
  If inhaled
    If breathed in, move person into fresh air. If not breathing, give artificial respiration. Consult a physician.
  In case of skin contact
    Wash off with soap and plenty of water. Take victim immediately to hospital. Consult a physician.
  In case of eye contact
    Rinse thoroughly with plenty of water for at least 15 minutes and consult a physician.
  If swallowed
    Do NOT induce vomiting. Never give anything by mouth to an unconscious person. Rinse mouth with
    water. Consult a physician.
  Most important symptoms and effects, both acute and delayed
    To the best of our knowledge, the chemical, physical, and toxicological properties have not been
    thoroughly investigated.
  Indication of any immediate medical attention and special treatment needed
    no data available

  Extinguishing media
  Suitable extinguishing media
    Use water spray, alcohol-resistant foam, dry chemical or carbon dioxide.
  Special hazards arising from the substance or mixture
    Carbon oxides, nitrogen oxides (NOx)
  Advice for firefighters
    Wear self contained breathing apparatus for fire fighting if necessary.
  Further information
    Use water spray to cool unopened containers.

  Personal precautions, protective equipment and emergency procedures
    Wear respiratory protection. Avoid breathing vapors, mist or gas. Ensure adequate ventilation. Remove
    all sources of ignition. Evacuate personnel to safe areas. Beware of vapours accumulating to form
    explosive concentrations. Vapours can accumulate in low areas.
  Environmental precautions
    Prevent further leakage or spillage if safe to do so. Do not let product enter drains.
  Methods and materials for containment and cleaning up
    Contain spillage, and then collect with an electrically protected vacuum cleaner or by wet-brushing and
    place in container for disposal according to local regulations (see section 13). Keep in suitable, closed
    containers for disposal.
  Reference to other sections
    For disposal see section 13.

  Precautions for safe handling
    Avoid contact with skin and eyes. Avoid inhalation of vapour or mist.
    Keep away from sources of ignition - No smoking.Take measures to prevent the build up of electrostatic
  Conditions for safe storage, including any incompatibilities
    Store in cool place. Keep container tightly closed in a dry and well-ventilated place. Containers which are
    opened must be carefully resealed and kept upright to prevent leakage.
    Recommended storage temperature: 2 - 8 °C
    Moisture sensitive. Light sensitive.
  Specific end uses
    no data available

  Control parameters
  Components with workplace control parameters
  Exposure controls
  Appropriate engineering controls
    Avoid contact with skin, eyes and clothing. Wash hands before breaks and immediately after handling
    the product.
  Personal protective equipment
  Eye/face protection
    Face shield and safety glasses Use equipment for eye protection tested and approved under
    appropriate government standards such as NIOSH (US) or EN 166(EU).
  Skin protection
    Handle with gloves. Gloves must be inspected prior to use. Use proper glove removal technique
    (without touching glove's outer surface) to avoid skin contact with this product. Dispose of
    contaminated gloves after use in accordance with applicable laws and good laboratory practices.
    Wash and dry hands.
    The selected protective gloves have to satisfy the specifications of EU Directive 89/686/EEC and
    the standard EN 374 derived from it.
  Body Protection
    Complete suit protecting against chemicals, The type of protective equipment must be selected
    according to the concentration and amount of the dangerous substance at the specific workplace.
  Respiratory protection
    Where risk assessment shows air-purifying respirators are appropriate use a full-face respirator
    with multi-purpose combination (US) or type ABEK (EN 14387) respirator cartridges as a backup
    to engineering controls. If the respirator is the sole means of protection, use a full-face supplied air
    respirator. Use respirators and components tested and approved under appropriate government
    standards such as NIOSH (US) or CEN (EU).

  Information on basic physical and chemical properties
    a) Appearance        Form: clear, liquid    
    Colour: light yellow
    b) Odour        no data available    
    c) Odour Threshold        no data available    
    d) pH        no data available    
    e) Melting point/freezing        no data available    
    f) Initial boiling point and 182 - 192 °C - lit.
    boiling range
    g) Flash point        64 °C - closed cup    
    h) Evaporation rate        no data available    
    i) Flammability (solid, gas) no data available
    j) Upper/lower        Lower explosion limit: 1,2 %(V)    
    flammability or
    explosive limits
    k) Vapour pressure        < 1 hPa at 25 °C    
    l) Vapour density        5,43 - (Air = 1.0)    
    m) Relative density        0,933 g/cm3 at 25 °C    
    n) Water solubility        no data available    
    o) Partition coefficient: n-        no data available    
    p) Autoignition        no data available    
    q) Decomposition        no data available    
    r) Viscosity        no data available    
    s) Explosive properties        no data available    
    t) Oxidizing properties        no data available    
  Other safety information
    no data available

    no data available
  Chemical stability
    no data available
    Contains the following stabiliser(s):
    Mequinol (*** ppm)
  Possibility of hazardous reactions
    no data available
  Conditions to avoid
    Heat, flames and sparks.
  Incompatible materials
    Strong acids, Strong bases, Strong oxidizing agents, Strong reducing agents
  Hazardous decomposition products
    Other decomposition products - no data available

  Information on toxicological effects
  Acute toxicity
    LD50 Oral - rat - 1.751 mg/kg
    LC50 Inhalation - rat - 4 h - 620 mg/m3
  Skin corrosion/irritation
    no data available
  Serious eye damage/eye irritation
    no data available
  Respiratory or skin sensitization
    May cause allergic skin reaction.
  Germ cell mutagenicity
    no data available
    IARC:        No component of this product present at levels greater than or equal to 0.1% is identified as    
    probable, possible or confirmed human carcinogen by IARC.
  Reproductive toxicity
    no data available
  Specific target organ toxicity - single exposure
    no data available
  Specific target organ toxicity - repeated exposure
    no data available
  Aspiration hazard
    no data available
  Potential health effects
  Inhalation        May be fatal if inhaled. Causes respiratory tract irritation.    
  Ingestion        Harmful if swallowed.    
  Skin        Harmful if absorbed through skin. Causes skin irritation.    
  Eyes        Causes serious eye irritation.    
  Signs and Symptoms of Exposure
    To the best of our knowledge, the chemical, physical, and toxicological properties have not been
    thoroughly investigated.
  Additional Information
    RTECS: OZ4200000

    Toxicity to fish        LC50 - Osteichthyes - 150 mg/l - 72 h    
    Toxicity to daphnia and semi-static test EC50 - Daphnia magna (Water flea) - 33 mg/l - 48 h
    other aquatic        Method: OECD Test Guideline 202    
    Toxicity to algae        static test EC50 - Scenedesmus capricornutum (fresh water algae) - 41,6 mg/l    
    - 72 h
    Method: OECD Test Guideline 201
  Persistence and degradability
    Biodegradability        aerobic - Exposure time 28 d    
    Result: 95,3 % - Readily biodegradable.
  Bioaccumulative potential
    no data available
  Mobility in soil
    no data available
  Results of PBT and vPvB assessment
    no data available
  Other adverse effects
    no data available

  Waste treatment methods
    This combustible material may be burned in a chemical incinerator equipped with an afterburner and
    scrubber. Offer surplus and non-recyclable solutions to a licensed disposal company.
  Contaminated packaging
    Dispose of as unused product.

  UN number
    ADR/RID: 2522        IMDG: 2522        IATA: 2522    
  UN proper shipping name
    IATA:        2-Dimethylaminoethyl methacrylate    
  Transport hazard class(es)
    ADR/RID: 6.1        IMDG: 6.1        IATA: 6.1    
  Packaging group
    ADR/RID: II        IMDG: II        IATA: II    
  Environmental hazards
    ADR/RID: no        IMDG Marine pollutant: no        IATA: no    
  Special precautions for user
    no data available

    This safety datasheet complies with the requirements of Regulation (EC) No. 1907/2006.
  Safety, health and environmental regulations/legislation specific for the substance or mixture
    no data available
  Chemical Safety Assessment
    no data available

  Further information
    Copyright 2012 Co. LLC. License granted to make unlimited paper copies for internal use
    The above information is believed to be correct but does not purport to be all inclusive and shall be
    used only as a guide. The information in this document is based on the present state of our knowledge
    and is applicable to the product with regard to appropriate safety precautions. It does not represent any
    guarantee of the properties of the product. Corporation and its Affiliates shall not be held
    liable for any damage resulting from handling or from contact with the above product. See
     and/or the reverse side of invoice or packing slip for additional terms and conditions of sale.

Home   |   Announcement   |   Partners   |   Business Cooperation   |   Suppliers   |   Products    |   About Us   |   Contact Us   |   Privacy Policy   |   Terms & Conditions   |   Legal Statement

Copyright © 2013-2016 MOLBASE All Rights Reserved ICP Shanghai 14014220