Recommended Suppliersmore
3-butoxyphenol 18979-72-1 MSDS

Section I.Chemical Product and Company Identification
    Chemical Name 3-Butoxyphenol
    Portland OR
    Synonym        Not available.    
    Chemical Formula        CH3(CH2)3OC6H4OH    
    CAS Number        18979-72-1    

Section II.        Composition and Information on Ingredients    
    Chemical Name        CAS Number Percent (%)        TLV/PEL        Toxicology Data    
    3-Butoxyphenol        18979-72-1        ------------- Not available.        Not available.    

Section III. Hazards Identification
    Acute Health Effects        Corrosive to skin, eyes, and respiratory system. Liquid or spray mist may produce tissue damage, particularly in mucous    
    membranes of the eyes, mouth and respiratory tract. Skin contact may produce burns. Eye contact can result in corneal
    damage or blindness. Inhalation of the spray mist may produce severe irritation of respiratory tract, characterized by
    coughing, choking, or shortness of breath. Corrosive materials may cause serious injury if ingested. Follow safe
    industrial hygiene practices and always wear proper protective equipment when handling this compound.
    Chronic Health Effects        CARCINOGENIC EFFECTS : Not available.    
    MUTAGENIC EFFECTS : Not available.
    TERATOGENIC EFFECTS : Not available.
    DEVELOPMENTAL TOXICITY: Not available.
    Repeated or prolonged contact with spray mist may produce chronic eye irritation and severe skin irritation. Repeated or
    prolonged exposure to spray mist may produce respiratory tract irritation leading to frequent attacks of bronchial
    infection.

Section IV.        First Aid Measures    
    Eye Contact        Check for and remove any contact lenses. DO NOT use an eye ointment. Flush eyes with running water for a minimum    
    of 15 minutes, occasionally lifting the upper and lower eyelids. Seek medical attention. Treat symptomatically and
    supportively.
    Skin Contact        If the chemical gets spilled on a clothed portion of the body, remove the contaminated clothes as quickly as possible,    
    protecting your own hands and body. Place the victim under a deluge shower. If the chemical touches the victim's
    exposed skin, such as the hands: Gently and thoroughly wash the contaminated skin with running water and non-abrasive
    soap. Be particularly careful to clean folds, crevices, creases and groin. Seek medical attention. Treat symptomatically
    and supportively. Wash any contaminated clothing before reusing.
    Inhalation        Evacuate the victim to a safe area as soon as possible. Loosen tight clothing such as a collar, tie, belt or waistband. If    
    breathing is difficult, administer oxygen. If the victim is not breathing, perform artificial respiration. WARNING: It may be
    dangerous to the person providing aid to give mouth-to-mouth resuscitation when the inhaled material is toxic, infectious
    or corrosive. Seek immediate medical attention and, if possible, show the chemical label. Treat symptomatically and
    supportively.
    Ingestion        DO NOT induce vomiting. Loosen tight clothing such as a collar, tie, belt, or waistband. If the victim is not breathing,    
    administer artificial respiration. Examine the lips and mouth to ascertain whether the tissues are damaged, a possible
    indication that the toxic material was ingested; the absence of such signs, however, is not conclusive. Seek immediate
    medical attention and, if possible, show the chemical label. Treat symptomatically and supportively.

Section V. Fire and Explosion Data
    Not available.
    Flammability        Combustible.        Auto-Ignition    
    Flash Points        Flammable Limits        Not available.    
    Not available.
    Combustion Products
    These products are toxic carbon oxides (CO, CO 2).
    Fire Hazards
    No specific information is available regarding the flammability of this compound in the presence of various materials.
    Continued on Next Page
    3-Butoxyphenol
    Risks of explosion of the product in presence of mechanical impact: Not available.
    Explosion Hazards
    Risks of explosion of the product in presence of static discharge: Not available.
    No additional information is available regarding the risks of explosion.
    Fire Fighting Media
    SMALL FIRE: Use DRY chemicals, CO 2, water spray or foam.
    LARGE FIRE: Use water spray, fog or foam. DO NOT use water jet.
    and Instructions

Section VI.        Accidental Release Measures    
    Spill Cleanup
    Corrosive liquid.
    Keep away from heat and sources of ignition. Mechanical exhaust required. Stop leak if without risk. Absorb with DRY
    Instructions
    earth, sand or other non-combustible material. DO NOT get water inside container. DO NOT touch spilled material. Use
    water spray curtain to divert vapor drift. Prevent entry into sewers, basements or confined areas; dike if needed.
    Eliminate all sources of ignition. Consult federal, state, and/or local authorities for assistance on disposal.

Section VII. Handling and Storage
    Handling and Storage        CORROSIVE. Keep container dry. Keep away from heat and sources of ignition. Mechanical exhaust required. When    
    not in use, tightly seal the container and store in a dry, cool place. Avoid excessive heat and light. DO NOT ingest. Do
    Information
    not breathe gas, fumes, vapor or spray. Avoid contact with eyes. Never add water to this product. In case of insufficient
    ventilation, wear suitable respiratory equipment. If ingested, seek medical advice immediately and show the container or
    the label. Treat symptomatically and supportively.
    Always store away from incompatible compounds such as oxidizing agents.

Section VIII. Exposure Controls/Personal Protection
    Engineering Controls        Provide exhaust ventilation or other engineering controls to keep the airborne concentrations of vapors below their    
    respective threshold limit value. Ensure that eyewash station and safety shower is proximal to the work-station location.
    Personal Protection        Face shield. Lab coat. Vapor respirator. Boots. Gloves. A MSHA/NIOSH approved respirator must be used to avoid    
    inhalation of the product. Suggested protective clothing might not be sufficient; consult a specialist BEFORE handling
    this product.
    Exposure Limits        Not available.    

Section IX. Physical and Chemical Properties
    Physical state @ 20°C        Slight yellow clear liquid.        Solubility    
    Not available.
    1.05
    Specific Gravity
    Molecular Weight        166.22        Partition Coefficient    
    Not available.
    Boiling Point        Not available.        Vapor Pressure        Not available.    
    Melting Point        Not available.        Vapor Density        Not available.    
    Not available.        Not available.    
    Refractive Index        Volatility    
    Critical Temperature        Not available.        Odor        Not available.    
    Viscosity        Not available.        Taste        Not available.    

Section X.        Stability and Reactivity Data    
    Stability    
This material is stable if stored under proper conditions. (See Section VII for instructions)    
    Conditions of Instability
    Avoid excessive heat and light.
    Incompatibilities
    Reactive with oxidizing agents.

Section XI. Toxicological Information
    RTECS Number        Not available.    
    Routes of Exposure        Eye contact. Inhalation. Ingestion. Skin contact.    
    Not available.
    Toxicity Data
    CARCINOGENIC EFFECTS : Not available.
    Chronic Toxic Effects
    MUTAGENIC EFFECTS : Not available.
    TERATOGENIC EFFECTS : Not available.
    DEVELOPMENTAL TOXICITY: Not available.
    Repeated or prolonged contact with spray mist may produce chronic eye irritation and severe skin irritation. Repeated or
    prolonged exposure to spray mist may produce respiratory tract irritation leading to frequent attacks of bronchial infection.
    Continued on Next Page
    3-Butoxyphenol
    Acute Toxic Effects        Corrosive to skin, eyes, and respiratory system. Liquid or spray mist may produce tissue damage, particularly in mucous    
    membranes of the eyes, mouth and respiratory tract. Skin contact may produce burns. Eye contact can result in corneal
    damage or blindness. Inhalation of the spray mist may produce severe irritation of respiratory tract, characterized by
    coughing, choking, or shortness of breath. Corrosive materials may cause serious injury if ingested. Follow safe
    industrial hygiene practices and always wear proper protective equipment when handling this compound.

Section XII.        Ecological Information    
    Ecotoxicity        Not available.    
    Environmental Fate        Not available.    

Section XIII. Disposal Considerations
    Recycle to process, if possible. Consult your local or regional authorities. You may be able to dissolve or mix material with
    Waste Disposal
    a combustible solvent and burn in a chemical incinerator equipped with an afterburner and scrubber system. Observe all
    federal, state, and local regulations when disposing of this substance.

Section XIV. Transport Information
    DOT Classification
    DOT CLASS 8: Corrosive liquid.
    PIN Number
    Proper Shipping Name
    Corrosive liquid, acidic, organic, n.o.s.
    Packing Group (PG)        III    
    DOT Pictograms

Section XV. Other Regulatory Information and Pictograms
    TSCA Chemical Inventory        This product is NOT on the EPA Toxic Substances Control Act (TSCA) inventory. The following notices are required by 40    
    CFR 720.36 (C) for those products not on the inventory list:
    (EPA)
    (i) These products are supplied solely for use in research and development by or under the supervision of a technically
    qualified individual as defined in 40 CFR 720.0 et sec.
    (ii) The health risks of these products have not been fully determined. Any information that is or becomes available will be
    supplied on an MSDS sheet.
    WHMIS Classification
    WHMIS CLASS D-2A: Material causing other toxic effects (VERY TOXIC).
    WHMIS CLASS E: Corrosive liquid.
    (Canada)
    EINECS Number (EEC) Not available.
    EEC Risk Statements        R35- Causes severe burns.    
    R41- Risk of serious damage to eyes.


SECTION 16 - ADDITIONAL INFORMATION
N/A

Home   |   Announcement   |   Partners   |   Business Cooperation   |   Suppliers   |   Products    |   About Us   |   Contact Us   |   Privacy Policy   |   Terms & Conditions   |   Legal Statement

Copyright © 2013-2016 MOLBASE All Rights Reserved ICP Shanghai 14014220