Recommended Suppliersmore
barium(2+),prop-2-enoate 17989-90-1 MSDS

Section I.Chemical Product and Company Identification
    Chemical Name Acrylic Acid Barium Salt, Monomer
    Portland OR
    Synonym        Barium acrylate, monomer    
    Chemical Formula        (CH2:CHCOO)2Ba    
    CAS Number        17989-90-1    

Section II.        Composition and Information on Ingredients    
    Chemical Name        CAS Number Percent (%)        TLV/PEL        Toxicology Data    
    Acrylic Acid Barium Salt, Monomer        17989-90-1 Min. 95.0 (T) Not available.        Not available.    

Section III. Hazards Identification
    Acute Health Effects        Toxic if ingested or inhaled. Avoid prolonged contact with this material. Overexposure may result in serious illness or    
    death. Follow safe industrial hygiene practices and always wear proper protective equipment when handling this
    compound.
    Chronic Health Effects        CARCINOGENIC EFFECTS : Not available.    
    MUTAGENIC EFFECTS : Not available.
    TERATOGENIC EFFECTS : Not available.
    DEVELOPMENTAL TOXICITY: Not available.
    Repeated exposure to an highly toxic material may produce general deterioration of health by an accumulation in one or
    many human organs.

Section IV.        First Aid Measures    
    Eye Contact        Check for and remove any contact lenses. IMMEDIATELY flush eyes with running water for at least 15 minutes, keeping    
    eyelids open. COLD water may be used. DO NOT use an eye ointment. Flush eyes with running water for a minimum of
    15 minutes, occasionally lifting the upper and lower eyelids. Seek medical attention. Treat symptomatically and
    supportively.
    Skin Contact        After contact with skin, wash immediately with plenty of water. Gently and thoroughly wash the contaminated skin with    
    running water and non-abrasive soap. Be particularly careful to clean folds, crevices, creases and groin. COLD water
    may be used. Cover the irritated skin with an emollient. Seek medical attention. Treat symptomatically and supportively.
    Wash any contaminated clothing before reusing.
    Inhalation        Evacuate the victim to a safe area as soon as possible. Loosen tight clothing such as a collar, tie, belt or waistband.    
    WARNING: It may be dangerous to the person providing aid to give mouth-to-mouth resuscitation when the inhaled
    material is toxic, infectious or corrosive. Seek immediate medical attention and, if possible, show the chemical label.
    Treat symptomatically and supportively.
    Ingestion        INDUCE VOMITING by sticking finger in throat. Lower the head so that the vomit will not reenter the mouth and throat.    
    Loosen tight clothing such as a collar, tie, belt, or waistband. If the victim is not breathing, administer artificial respiration.
    Examine the lips and mouth to ascertain whether the tissues are damaged, a possible indication that the toxic material
    was ingested; the absence of such signs, however, is not conclusive. Seek immediate medical attention and, if possible,
    show the chemical label. Treat symptomatically and supportively.

Section V. Fire and Explosion Data
    Auto-Ignition        Not available.    
    Flammability        Combustible.    
    Flash Points        Flammable Limits        Not available.    
    Not available.
    Combustion Products        These products are toxic carbon oxides (CO, CO 2), metallic oxides.    
    Fire Hazards
    No specific information is available regarding the flammability of this compound in the presence of various materials.
    Explosion Hazards        Risks of explosion of the product in presence of mechanical impact: Not available.    
    Risks of explosion of the product in presence of static discharge: Not available.
    No additional information is available regarding the risks of explosion.
    Continued on Next Page
    Acrylic Acid Barium Salt, Monomer
    Fire Fighting Media
    SMALL FIRE: Use DRY chemicals, CO 2, water spray or foam.
    and Instructions        LARGE FIRE: Use water spray, fog or foam. DO NOT use water jet.    

Section VI.        Accidental Release Measures    
    Spill Cleanup        Toxic solid.    
    Instructions        Stop leak if without risk. DO NOT get water inside container. DO NOT touch spilled material. Use water spray to reduce    
    vapors. Prevent entry into sewers, basements or confined areas; dike if needed. Eliminate all sources of ignition.
    Consult federal, state, and/or local authorities for assistance on disposal.

Section VII. Handling and Storage
    Handling and Storage        TOXIC SOLID. Handle with caution and minimize exposure. Keep away from heat and sources of ignition. Mechanical    
    exhaust required. When not in use, tightly seal the container and store in a dry, cool place. Avoid excessive heat and
    Information
    light. DO NOT ingest. DO NOT breathe dust. In case of insufficient ventilation, wear suitable respiratory equipment. If
    ingested, seek medical advice immediately and show the container or the label. Treat symptomatically and supportively.
    Avoid contact with skin and eyes.
    Always store away from incompatible compounds such as oxidizing agents.

Section VIII. Exposure Controls/Personal Protection
    Engineering Controls        Use process enclosures, local exhaust ventilation, or other engineering controls to keep airborne levels below    
    recommended exposure limits. If user operations generate dust, fume or mist, use ventilation to keep exposure to
    airborne contaminants below the exposure limit.
    Personal Protection        Splash goggles. Lab coat. Dust respirator. Boots. Gloves. A MSHA/NIOSH approved respirator must be used to avoid    
    inhalation of the product. Suggested protective clothing might not be sufficient; consult a specialist BEFORE handling
    this product.
    Exposure Limits        Not available.    

Section IX. Physical and Chemical Properties
    Solubility
    Physical state @ 20°C        Solid.        Soluble in cold water, hot water.    
    Not available.
    Specific Gravity
    Molecular Weight        279.44        Partition Coefficient        Not available.    
    Boiling Point        Not available.        Vapor Pressure        Not available.    
    Melting Point        Not available.        Vapor Density        Not available.    
    Not available.        Volatility        Not available.    
    Refractive Index
    Critical Temperature        Odor        Not available.    
    Not available.
    Viscosity        Not available.        Taste        Not available.    

Section X.        Stability and Reactivity Data    
    Stability    
This material is stable if stored under proper conditions. (See Section VII for instructions)    
    Conditions of Instability
    Avoid excessive heat and light.
    Incompatibilities
    Reactive with oxidizing agents.

Section XI. Toxicological Information
    RTECS Number        Not available.    
    Routes of Exposure        Eye contact. Inhalation. Ingestion. Skin contact.    
    Not available.
    Toxicity Data
    Chronic Toxic Effects        CARCINOGENIC EFFECTS : Not available.    
    MUTAGENIC EFFECTS : Not available.
    TERATOGENIC EFFECTS : Not available.
    DEVELOPMENTAL TOXICITY: Not available.
    Repeated exposure to an highly toxic material may produce general deterioration of health by an accumulation in one or
    many human organs.
    Acute Toxic Effects        Toxic if ingested or inhaled. Avoid prolonged contact with this material. Overexposure may result in serious illness or    
    death. Follow safe industrial hygiene practices and always wear proper protective equipment when handling this
    compound.
    Continued on Next Page
    Acrylic Acid Barium Salt, Monomer

Section XII.        Ecological Information    
    Ecotoxicity        Not available.    
    Environmental Fate        Not available.    

Section XIII. Disposal Considerations
    Recycle to process, if possible. Consult your local or regional authorities. You may be able to dissolve or mix material with
    Waste Disposal
    a combustible solvent and burn in a chemical incinerator equipped with an afterburner and scrubber system. Observe all
    federal, state, and local regulations when disposing of this substance.

Section XIV. Transport Information
    DOT Classification        DOT CLASS 6.1: Toxic material.    
    PIN Number
    Proper Shipping Name
    Barium compounds, n.o.s.
    Packing Group (PG)        III    
    DOT Pictograms

Section XV. Other Regulatory Information and Pictograms
    TSCA Chemical Inventory        This product is NOT on the EPA Toxic Substances Control Act (TSCA) inventory. The following notices are required by 40    
    CFR 720.36 (C) for those products not on the inventory list:
    (EPA)
    (i) These products are supplied solely for use in research and development by or under the supervision of a technically
    qualified individual as defined in 40 CFR 720.0 et sec.
    (ii) The health risks of these products have not been fully determined. Any information that is or becomes available will be
    supplied on an MSDS sheet.
    WHMIS Classification        Not controlled under WHMIS (Canada).    
    (Canada)
    EINECS Number (EEC) Not available.
    EEC Risk Statements        R26/27/28- Very toxic by inhalation, in contact with skin and if swallowed.    


SECTION 16 - ADDITIONAL INFORMATION
N/A

Home   |   Announcement   |   Partners   |   Business Cooperation   |   Suppliers   |   Products    |   About Us   |   Contact Us   |   Privacy Policy   |   Terms & Conditions   |   Legal Statement

Copyright © 2013-2016 MOLBASE All Rights Reserved ICP Shanghai 14014220