Recommended Suppliersmore
m-Anisoyl chloride
CAS No.: 1711-05-3
Synonyms:
Formula: C8H7ClO2
Exact Mass: 170.01300
Molecular Weight: 170.59300
PSA: 26.30000
LogP: 2.07420
Reference Price: $504/kg Inquiry Now
m-Anisoyl chloride 1711-05-3 MSDS
Name: Meta-Anisoyl Chloride 99% Material Safety Data Sheet
Synonym: None known
CAS: 1711-05-3
Section 1 - Chemical Product   MSDS Name:Meta-Anisoyl Chloride 99% Material Safety Data Sheet
Synonym:None known

Section 2 - COMPOSITION, INFORMATION ON INGREDIENTS
CAS# Chemical Name content EINECS#
1711-05-3 Meta-Anisoyl Chloride 99 216-975-2
Hazard Symbols: C
Risk Phrases: 34

Section 3 - HAZARDS IDENTIFICATION
  EMERGENCY OVERVIEW
Causes burns.Moisture sensitive.Corrosive.
Potential Health Effects
Eye:
Causes eye burns. Contact with eyes may cause severe irritation, and possible eye burns. May cause chemical conjunctivitis and corneal damage.
Skin:
Causes skin burns. May cause severe irritation and possible burns.
May cause skin rash (in milder cases), and cold and clammy skin with cyanosis or pale color.
Ingestion:
May cause severe and permanent damage to the digestive tract. Causes gastrointestinal tract burns. May cause perforation of the digestive tract. May cause systemic effects.
Inhalation:
May cause severe irritation of the respiratory tract with sore throat, coughing, shortness of breath and delayed lung edema. Causes chemical burns to the respiratory tract. Aspiration may lead to pulmonary edema. May cause systemic effects.
Chronic:
Effects may be delayed.

Section 4 - FIRST AID MEASURES
  Eyes: Get medical aid immediately. Do NOT allow victim to rub eyes or keep eyes closed. Extensive irrigation with water is required (at least 30 minutes).
Skin:
Get medical aid. Get medical aid immediately. Flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Immediately flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Wash clothing before reuse. Remove contaminated clothing and shoes.
Destroy contaminated shoes.
Ingestion:
Do not induce vomiting. If victim is conscious and alert, give 2-4 cupfuls of milk or water. Never give anything by mouth to an unconscious person. Get medical aid immediately.
Inhalation:
Get medical aid immediately. Remove from exposure and move to fresh air immediately. If breathing is difficult, give oxygen. Do NOT use mouth-to-mouth resuscitation. If breathing has ceased apply artificial respiration using oxygen and a suitable mechanical device such as a bag and a mask.
Notes to Physician:

Section 5 - FIRE FIGHTING MEASURES
  General Information:
As in any fire, wear a self-contained breathing apparatus in pressure-demand, MSHA/NIOSH (approved or equivalent), and full protective gear. During a fire, irritating and highly toxic gases may be generated by thermal decomposition or combustion.
Extinguishing Media:
Not available.

Section 6 - ACCIDENTAL RELEASE MEASURES
  General Information: Use proper personal protective equipment as indicated in Section 8.
Spills/Leaks:
Clean up spills immediately, observing precautions in the Protective Equipment section. Provide ventilation.

Section 7 - HANDLING and STORAGE
  Handling:
Use only in a well-ventilated area. Do not breathe dust, vapor, mist, or gas. Do not get in eyes, on skin, or on clothing. Keep container tightly closed. Do not ingest or inhale. Discard contaminated shoes.
Storage:
Keep container closed when not in use. Corrosives area.

Section 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION
  Engineering Controls:
Facilities storing or utilizing this material should be equipped with an eyewash facility and a safety shower. Use adequate ventilation to keep airborne concentrations low.
Exposure Limits CAS# 1711-05-3: Personal Protective Equipment Eyes: Wear appropriate protective eyeglasses or chemical safety goggles as described by OSHA's eye and face protection regulations in 29 CFR 1910.133 or European Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin exposure.
Clothing:
Wear appropriate protective clothing to prevent skin exposure.
Respirators:
A respiratory protection program that meets OSHA's 29 CFR 1910.134 and ANSI Z88.2 requirements or European Standard EN 149 must be followed whenever workplace conditions warrant respirator use.

Section 9 - PHYSICAL AND CHEMICAL PROPERTIES
 
Physical State: Liquid
Color: very slightly yellow
Odor: Not available.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: 123.0 - 125.0 deg C @ 15.00mm
Freezing/Melting Point: 0 deg C
Autoignition Temperature: Not available.
Flash Point: 92 deg C ( 197.60 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water: may decompose
Specific Gravity/Density: 1.2140g/cm3
Molecular Formula: C8H7ClO2
Molecular Weight: 170.60

Section 10 - STABILITY AND REACTIVITY
  Chemical Stability:
Not available.
Conditions to Avoid:
Not available.
Incompatibilities with Other Materials:
Not available.
Hazardous Decomposition Products:
Not available.
Hazardous Polymerization: Not available.

Section 11 - TOXICOLOGICAL INFORMATION
  RTECS#:
CAS# 1711-05-3 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
Meta-Anisoyl Chloride - Not listed by ACGIH, IARC, or NTP.

Section 12 - ECOLOGICAL INFORMATION
 

Section 13 - DISPOSAL CONSIDERATIONS
  Dispose of in a manner consistent with federal, state, and local regulations.

Section 14 - TRANSPORT INFORMATION
 
IATA
Shipping Name: ANISOYL CHLORIDE
Hazard Class: 8
UN Number: 1729
Packing Group: II
IMO
Shipping Name: ANISOYL CHLORIDE
Hazard Class: 8
UN Number: 1729
Packing Group: II
RID/ADR
Shipping Name: ANISOYL CHLORIDE
Hazard Class: 8
UN Number: 1729
Packing group: II

Section 15 - REGULATORY INFORMATION
 
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: C
Risk Phrases:
R 34 Causes burns.
Safety Phrases:
S 36/39 Wear suitable protective clothing and
eye/face protection.
WGK (Water Danger/Protection)
CAS# 1711-05-3: No information available.
Canada
None of the chemicals in this product are listed on the DSL/NDSL list.
CAS# 1711-05-3 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 1711-05-3 is not listed on the TSCA inventory.
It is for research and development use only.


SECTION 16 - ADDITIONAL INFORMATION
N/A

Home   |   Announcement   |   Partners   |   Business Cooperation   |   Suppliers   |   Products    |   About Us   |   Contact Us   |   Privacy Policy   |   Terms & Conditions   |   Legal Statement

Copyright © 2013-2016 MOLBASE All Rights Reserved ICP Shanghai 14014220