putrescine 110-60-1 MSDS
Name: 1 4-Diaminobutane 99% Material Safety Data Sheet
Synonym: Putrescine; 1,4-Butanediamin
CAS: 110-60-1
Section 1 - Chemical Product   MSDS Name:1 4-Diaminobutane 99% Material Safety Data Sheet
Synonym:Putrescine; 1,4-Butanediamin

Section 2 - COMPOSITION, INFORMATION ON INGREDIENTS
CAS# Chemical Name content EINECS#
110-60-1 1,4-Diaminobutane 99 203-782-3
Hazard Symbols: XN C
Risk Phrases: 21/22 34

Section 3 - HAZARDS IDENTIFICATION
  EMERGENCY OVERVIEW
Harmful in contact with skin and if swallowed. Causes burns.Corrosive.
Potential Health Effects
Eye:
Causes eye burns.
Skin:
Causes skin burns. May be harmful if absorbed through the skin.
Ingestion:
Harmful if swallowed. May cause severe and permanent damage to the digestive tract. Causes gastrointestinal tract burns.
Inhalation:
May cause severe irritation of the respiratory tract with sore throat, coughing, shortness of breath and delayed lung edema. Causes chemical burns to the respiratory tract.
Chronic:
No information found.

Section 4 - FIRST AID MEASURES
  Eyes: Get medical aid immediately. Do NOT allow victim to rub eyes or keep eyes closed. Extensive irrigation with water is required (at least 30 minutes).
Skin:
Get medical aid immediately. Immediately flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Wash clothing before reuse. Destroy contaminated shoes.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical aid immediately. Do NOT induce vomiting. If conscious and alert, rinse mouth and drink 2-4 cupfuls of milk or water.
Inhalation:
Get medical aid immediately. Remove from exposure and move to fresh air immediately. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Do NOT use mouth-to-mouth resuscitation.
Notes to Physician:

Section 5 - FIRE FIGHTING MEASURES
  General Information:
As in any fire, wear a self-contained breathing apparatus in pressure-demand, MSHA/NIOSH (approved or equivalent), and full protective gear. During a fire, irritating and highly toxic gases may be generated by thermal decomposition or combustion. Use water spray to keep fire-exposed containers cool. Containers may explode in the heat of a fire. Vapors may be heavier than air. They can spread along the ground and collect in low or confined areas.
Extinguishing Media:
In case of fire, use water, dry chemical, chemical foam, or alcohol-resistant foam. Cool containers with flooding quantities of water until well after fire is out.

Section 6 - ACCIDENTAL RELEASE MEASURES
  General Information: Use proper personal protective equipment as indicated in Section 8.
Spills/Leaks:
Clean up spills immediately, observing precautions in the Protective Equipment section. Sweep up, then place into a suitable container for disposal. Avoid generating dusty conditions. Provide ventilation.

Section 7 - HANDLING and STORAGE
  Handling:
Keep container tightly closed. Do not get on skin or in eyes. Do not ingest or inhale. Use with adequate ventilation. Discard contaminated shoes.
Storage:
Keep container closed when not in use. Store in a cool, dry, well-ventilated area away from incompatible substances. Corrosives area.

Section 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION
  Engineering Controls:
Facilities storing or utilizing this material should be equipped with an eyewash facility and a safety shower. Use adequate ventilation to keep airborne concentrations low.
Exposure Limits CAS# 110-60-1: Personal Protective Equipment Eyes: Wear appropriate protective eyeglasses or chemical safety goggles as described by OSHA's eye and face protection regulations in 29 CFR 1910.133 or European Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin exposure.
Clothing:
Wear appropriate protective clothing to minimize contact with skin.
Respirators:
A respiratory protection program that meets OSHA's 29 CFR 1910.134 and ANSI Z88.2 requirements or European Standard EN 149 must be followed whenever workplace conditions warrant respirator use.

Section 9 - PHYSICAL AND CHEMICAL PROPERTIES
 
Physical State: Crystals
Color: yellow to brown
Odor: None reported.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: 158.0 - 160.0 deg C @ 760.00m
Freezing/Melting Point: 27.00 - 28.00 deg C
Autoignition Temperature: Not available.
Flash Point: 63 deg C ( 145.40 deg F)
Explosion Limits, lower: N/A
Explosion Limits, upper: N/A
Decomposition Temperature:
Solubility in water: 40 g/l (20 c)
Specific Gravity/Density: .8770g/cm3
Molecular Formula: C4H12N2
Molecular Weight: 88.15

Section 10 - STABILITY AND REACTIVITY
  Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, dust generation, excess heat, oxidizers.
Incompatibilities with Other Materials:
Strong oxidizing agents.
Hazardous Decomposition Products:
Nitrogen oxides, carbon monoxide, irritating and toxic fumes and gases, carbon dioxide, nitrogen.
Hazardous Polymerization: Has not been reported.

Section 11 - TOXICOLOGICAL INFORMATION
  RTECS#:
CAS# 110-60-1: EJ6800000 LD50/LC50:
CAS# 110-60-1: Oral, rat: LD50 = 463 mg/kg; Skin, rabbit: LD50 = 1576 mg/kg.
Oral, rat: LD50=463mg/kg Carcinogenicity:
1,4-Diaminobutane - Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.

Section 12 - ECOLOGICAL INFORMATION
 

Section 13 - DISPOSAL CONSIDERATIONS
  Dispose of in a manner consistent with federal, state, and local regulations.

Section 14 - TRANSPORT INFORMATION
 
IATA
Shipping Name: CAUSTIC ALKALI LIQUID, N.O.S.*
Hazard Class: 8
UN Number: 1719
Packing Group: II
IMO
Shipping Name: CAUSTIC ALKALI LIQUID, N.O.S.
Hazard Class: 8
UN Number: 1719
Packing Group: II
RID/ADR
Shipping Name: CAUSTIC ALKALI LIQUID, N.O.S.
Hazard Class: 8
UN Number: 1719
Packing group: II

Section 15 - REGULATORY INFORMATION
 
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XN C
Risk Phrases:
R 21/22 Harmful in contact with skin and if
swallowed.
R 34 Causes burns.
Safety Phrases:
S 28A After contact with skin, wash immediately with
plenty of water.
WGK (Water Danger/Protection)
CAS# 110-60-1: 2
Canada
CAS# 110-60-1 is listed on Canada's NDSL List.
CAS# 110-60-1 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 110-60-1 is listed on the TSCA inventory.


SECTION 16 - ADDITIONAL INFORMATION
N/A

Home   |   Announcement   |   Partners   |   Business Cooperation   |   Suppliers   |   Products    |   About Us   |   Contact Us   |   Privacy Policy   |   Terms & Conditions   |   Legal Statement

Copyright © 2013-2016 MOLBASE All Rights Reserved ICP Shanghai 14014220