Recommended Suppliersmore
1-Propanesulfonyl chloride 10147-36-1 MSDS
Name: 1-Propanesulfonyl chloride 99% (titr.) Material Safety Data Sheet
Synonym:
CAS: 10147-36-1
Section 1 - Chemical Product   MSDS Name:1-Propanesulfonyl chloride 99% (titr.) Material Safety Data Sheet
Synonym:

Section 2 - COMPOSITION, INFORMATION ON INGREDIENTS
CAS# Chemical Name content EINECS#
10147-36-1 1-Propanesulfonyl chloride 99.0 233-414-7
Hazard Symbols: T C
Risk Phrases: 25 34

Section 3 - HAZARDS IDENTIFICATION
  EMERGENCY OVERVIEW
Toxic if swallowed. Causes burns.Moisture sensitive.Corrosive.
Potential Health Effects
Eye:
Causes eye burns. Lachrymator (substance which increases the flow of tears).
Skin:
Causes skin burns.
Ingestion:
May cause severe and permanent damage to the digestive tract. Poison by ingestion. Causes gastrointestinal tract burns.
Inhalation:
Causes chemical burns to the respiratory tract. Inhalation may be fatal as a result of spasm, inflammation, edema of the larynx and bronchi, chemical pneumonitis and pulmonary edema.
Chronic:
No information found.

Section 4 - FIRST AID MEASURES
  Eyes: Immediately flush eyes with plenty of water for at least 15 minutes, occasionally lifting the upper and lower eyelids. Get medical aid immediately. Do NOT allow victim to rub eyes or keep eyes closed.
Extensive irrigation with water is required (at least 30 minutes).
Skin:
Get medical aid immediately. Immediately flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Wash clothing before reuse. Destroy contaminated shoes.
Ingestion:
Do not induce vomiting. If victim is conscious and alert, give 2-4 cupfuls of milk or water. Never give anything by mouth to an unconscious person. Get medical aid immediately.
Inhalation:
Get medical aid immediately. Remove from exposure and move to fresh air immediately. If breathing is difficult, give oxygen. Do NOT use mouth-to-mouth resuscitation. If breathing has ceased apply artificial respiration using oxygen and a suitable mechanical device such as a bag and a mask.
Notes to Physician:
Antidote: None reported.

Section 5 - FIRE FIGHTING MEASURES
  General Information:
As in any fire, wear a self-contained breathing apparatus in pressure-demand, MSHA/NIOSH (approved or equivalent), and full protective gear. During a fire, irritating and highly toxic gases may be generated by thermal decomposition or combustion. Use water spray to keep fire-exposed containers cool. Combustible liquid.
Containers may explode when heated.
Extinguishing Media:
In case of fire, use water, dry chemical, chemical foam, or alcohol-resistant foam. Use water spray to cool fire-exposed containers.

Section 6 - ACCIDENTAL RELEASE MEASURES
  General Information: Use proper personal protective equipment as indicated in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth), then place in suitable container. Clean up spills immediately, observing precautions in the Protective Equipment section. Remove all sources of ignition. Provide ventilation.

Section 7 - HANDLING and STORAGE
  Handling:
Wash thoroughly after handling. Do not breathe dust, vapor, mist, or gas. Do not get in eyes, on skin, or on clothing. Empty containers retain product residue, (liquid and/or vapor), and can be dangerous.
Keep container tightly closed. Keep away from heat, sparks and flame.
Use only in a chemical fume hood. Discard contaminated shoes. Do not pressurize, cut, weld, braze, solder, drill, grind, or expose empty containers to heat, sparks or open flames.
Storage:
Keep away from heat, sparks, and flame. Keep away from sources of ignition. Keep container closed when not in use. Store in a tightly closed container. Store in a cool, dry, well-ventilated area away from incompatible substances. Corrosives area.

Section 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION
  Engineering Controls:
Facilities storing or utilizing this material should be equipped with an eyewash facility and a safety shower. Use adequate ventilation to keep airborne concentrations low.
Exposure Limits CAS# 10147-36-1: Personal Protective Equipment Eyes: Wear appropriate protective eyeglasses or chemical safety goggles as described by OSHA's eye and face protection regulations in 29 CFR 1910.133 or European Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin exposure.
Clothing:
Wear appropriate protective clothing to prevent skin exposure.
Respirators:
Follow the OSHA respirator regulations found in 29 CFR 1910.134 or European Standard EN 149. Use a NIOSH/MSHA or European Standard EN 149 approved respirator if exposure limits are exceeded or if irritation or other symptoms are experienced.

Section 9 - PHYSICAL AND CHEMICAL PROPERTIES
 
Physical State: Liquid
Color: pale yellow
Odor: Not available.
pH: Not available.
Vapor Pressure: 0.48 mm Hg @ 20
Viscosity: Not available.
Boiling Point: 66 deg C @ 8.00MM HG
Freezing/Melting Point: -46 deg C
Autoignition Temperature: Not available.
Flash Point: 91 deg C ( 195.80 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water: decomposes in hot water
Specific Gravity/Density: 1.2800g/cm3
Molecular Formula: C3H7ClO2S
Molecular Weight: 142.61

Section 10 - STABILITY AND REACTIVITY
  Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, ignition sources, excess heat, exposure to moist air or water.
Incompatibilities with Other Materials:
Strong oxidizing agents, strong bases, alcohols.
Hazardous Decomposition Products:
Hydrogen chloride, carbon monoxide, oxides of sulfur, carbon dioxide.
Hazardous Polymerization: Will not occur.

Section 11 - TOXICOLOGICAL INFORMATION
  RTECS#:
CAS# 10147-36-1 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
1-Propanesulfonyl chloride - Not listed by ACGIH, IARC, or NTP.

Section 12 - ECOLOGICAL INFORMATION
 

Section 13 - DISPOSAL CONSIDERATIONS
  Dispose of in a manner consistent with federal, state, and local regulations.

Section 14 - TRANSPORT INFORMATION
 
IATA
Shipping Name: CORROSIVE LIQUID, TOXIC, N.O.S.*
Hazard Class: 8 (6.1)
UN Number: 2922
Packing Group: II
IMO
Shipping Name: CORROSIVE LIQUID, TOXIC, N.O.S.
Hazard Class: 8 (6.1)
UN Number: 2922
Packing Group: II
RID/ADR
Shipping Name: CORROSIVE LIQUID, TOXIC, N.O.S.
Hazard Class: 8
UN Number: 2922
Packing group: II

Section 15 - REGULATORY INFORMATION
 
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: T C
Risk Phrases:
R 25 Toxic if swallowed.
R 34 Causes burns.
Safety Phrases:
S 25 Avoid contact with eyes.
S 28A After contact with skin, wash immediately with
plenty of water.
S 36/37/39 Wear suitable protective clothing, gloves
and eye/face protection.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
WGK (Water Danger/Protection)
CAS# 10147-36-1: No information available.
Canada
CAS# 10147-36-1 is listed on Canada's NDSL List.
CAS# 10147-36-1 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 10147-36-1 is listed on the TSCA inventory.


SECTION 16 - ADDITIONAL INFORMATION
N/A

Home   |   Announcement   |   Partners   |   Business Cooperation   |   Suppliers   |   Products    |   About Us   |   Contact Us   |   Privacy Policy   |   Terms & Conditions   |   Legal Statement

Copyright © 2013-2016 MOLBASE All Rights Reserved ICP Shanghai 14014220